Q. The highest temperature during the cycle in a vapour compression system occurs after evaporation.

View solution

Q. The rato of energy transferred by convection to that by conduction is called

View solution

Q. A refrigerating system operating on reversed Brayton refrigeration cycle is used for maintaining 250 K. If the temperature at the end of constant pressure cooling is 300 K and rise in the temperature of air in the refrigerator is 50 K, then the net work of compression will be (assume air as working substance with cp = 1 kJ/kg)

View solution

Q. Wet bulb temperature indicates the moisture content in air.

View solution

Q. A designer chooses the values of fluid flow rates and specific heats in such a manner that the heat capacities of the two fluids are equal. A hot fluid enters the counter flow heat exchanger at 100° C and leaves at 60° C. A cold fluid enters the heat exchanger at 40° C. The mean temperature difference between the two fluids is

View solution

Q. The inclined and non-uniformly spaced straight lines on a psychrometric chart indicates wet bulb temperature.

View solution

Q. In a psychrometric chart, dew point temperature lines are horizontal and non-uniformly spaced.

View solution

Q. If the evaporator temperature is kept constant, the coefficient of performance of a refrigeration cycle __________ with the increase in condenser temperature.

View solution

Q. The by-pass factor, in case of sensible cooling of air, is given by (where td1 = Dry bulb temperature of air entering the cooling coil, td2 = Dry bulb temperature of air leaving the cooling coil, and td3 = Dry bulb temperature of the cooling coil)

View solution

Q. The evaporator used in house-hold refrigerators is

View solution

Q. The drier in a refrigeration system removes moisture in the system.

View solution

Q. When the discharge pressure is too high in a refrigeration system, high pressure control is installed to stop the compressor.

View solution

Q. A grey body is one whose absorptivity does not vary with temperature and wave length of the incident ray.

View solution

Q. The wet bulb temperature during sensible cooling of air

View solution

Q. In absorption vapour systems, the refrigerant widely used is R-12.

View solution

Q. Hydrogen is used in electrolux refrigeration system so as to __________ the rate of evaporation of the liquid ammonia passing through the evaporator.

View solution

Q. Dry bulb temperature is the temperature of air recorded by a thermometer, when

View solution

Q. In a spray washing system, if the temperature of water is higher than the dry bulb temperature of entering air, then the air is

View solution

Q. A valve which maintains a constant degree of superheat at the end of the evaporator coil, is called

View solution

Q. The atmospheric air at dry bulb temperature of 15°C enters a heating coil maintained at 40°C. The air leaves the heating coil at 25°C. The by-pass factor of the heating coil is

View solution