Question

In a refrigeration system, the expansion device is connected between the

a.

compressor and condenser

b.

condenser and receiver

c.

receiver and evaporator

d.

evaporator and compressor

Answer: (c).receiver and evaporator

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In a refrigeration system, the expansion device is connected between the

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The heat rejection factor (HRF) is given by

Q. Wein's law states that the wave length corresponding to __________ is proportional to the absolute temperature.

Q. In a domestic vapour compression refrigerator, the refrigerant commonly used is

Q. In case of sensible heating of air, the coil efficiency is given by (where B.P.F. = By-pass factor)

Q. The coefficient of performance (C.O.P.) is the reciprocal of the efficiency of a heat engine.

Q. The wet bulb temperature at 100% relative humidity is __________ dry bulb temperature.

Q. The freezing point of sulphur dioxide is

Q. The ratio of the energy absorbed by the body to the total energy falling on it, is called

Q. In order to cool and dehumidify a stream of moist air, it must be passed over the coil at a temperature

Q. The coefficient of performance of vapour compression refrigeration system is quite __________ as compared to air refrigeration system.

Q. In order to collect liquid refrigerant and to prevent it from going to a __________ , a device known as accumulator is used at the suction of compressor.

Q. Which of the following refrigerant has the lowest boiling point?

Q. During sensible cooling of air, the relative humidity increases.

Q. Sensible heat factor is given by (where S.H. = Sensible heat, and L.H. = Latent heat)

Q. Stefan-Boltzmann law is applicable for heat transfer by convection.

Q. The most commonly used method for the design of duct size is the

Q. In counter-current flow heat exchangers

Q. The rate of heat flow through a body is . The term x/kA is known as

Q. In actual air-conditioning applications for R-12 and R-22, and operating at a condenser temperature of 40° C and an evaporator temperature of 5° C, the heat rejection factor is about

Q. The undesireable property of a refrigerant is

Recommended Subjects

Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!