Q. A condenser is used in the __________ pressure side of a refrigerating system.

View solution

Q. A steam pipe is to be lined with two layers of insulating materials of different thermal conductivities. For the minimum heat transfer,

View solution

Q. In a parallel flow heat exchanger, the rate of flow of heat and the rate of decrease of temperature are maximum.

View solution

Q. When the air is passed through an insulated chamber having sprays of water maintained at a temperature higher than the dew point temperature of entering air but lower than its dry bulb temperature, then the air is said to be

View solution

Q. Which of the following statement is wrong?

View solution

Q. In a domestic refrigerator, a capillary tube controls the flow of refrigerant from the

View solution

Q. The absolute humidity is the mass of water vapour present in 1 m³ of dry air.

View solution

Q. In a vapour absorption refrigeration system, the compressor of the vapour compression system is replaced by

View solution

Q. The refrigerant used in small-tonnage commercial machines (hermetically sealed units) is

View solution

Q. In a lithium bromide absorption refrigeration system

View solution

Q. The heat transfer from a hot body to a cold body is directly proportional to the surface area and difference of temperatures between the two bodies. This statement is called

View solution

Q. The pressure at the inlet of a refrigerant compressor is called

View solution

Q. The process, generally used in summer air conditioning to cool and dehumidify the air, is called

View solution

Q. The leakage in a refrigeration system using ammonia is detected by

View solution

Q. The lowest temperature during the cycle in a vapour compression system occurs after

View solution

Q. Which of the following represents a heat pump?

View solution

Q. In figure shown, E is a heat engine with efficiency of 0.4 and R is a refrigerator. It is given that Q2 + Q4 = 3Q1. The C.O.P. of the refrigerator is

View solution