Q. Grinding wheels should be tested for balance

View solution

Q. The lip angle of a single point tool is usually

View solution

Q. The average cutting speed for turning brass with a high speed steel tool is

View solution

Q. The maximum production of small and slender parts is done by

View solution

Q. Side rake angle on tools is provided to control chip flow.

View solution

Q. The method of grinding used to produce a straight or tapered surface on a workpiece, is

View solution

Q. Segmental chips are formed during machining

View solution

Q. Cemented carbide tool tips are produced by powder metallurgy.

View solution

Q. If the diameter of the hole is subject to considerable variation, then for locating in jigs and fixtures, the pressure type of locator used is

View solution

Q. Side rake angle of a single point cutting tool is the angle

View solution

Q. Internal gears can be made by

View solution

Q. The machining of titanium is difficult due to

View solution

Q. In orthogonal cutting system, the maximum chip thickness occurs at the middle.

View solution

Q. Lapping is an operation of

View solution

Q. The different spindle speeds on a lathe form

View solution

Q. If the helix angle of the drill is made __________ 30°, then the torque required to drive the drill at a given feed will be more.

View solution

Q. A fixture does not guide the tool.

View solution

Q. Crater wear occurs mainly on the

View solution

Q. Gear lapping is an operation

View solution

Q. The facing is an operation of

View solution