Q. Drilling is an example of

View solution

Q. A round nose tool may be fed eitner from left to right end or from right to left end of the lathe bed.

View solution

Q. When the cutting edge of the tool is dull, then during machining

View solution

Q. A drill considered as a cutting tool having zero rake, is known as a

View solution

Q. Which of the following statement is wrong about ultra-sonic machining?

View solution

Q. In oblique cutting system, the maximum chip thickness occurs at the middle.

View solution

Q. Larger end cutting edge angle __________ tool life.

View solution

Q. The lead screw of a lathe has __________ threads.

View solution

Q. The depth of cut in drilling is __________ the drill diameter.

View solution

Q. The type of tool used on lathe, shaper and planer is

View solution

Q. A __________ grinding wheel is used to grind soft materials.

View solution

Q. The relation between tool life (T) and cutting speed (V) is VTn = Constant. In this relation, the value of n depends upon

View solution

Q. In order to grind soft material

View solution

Q. Back rake angle of a single point tool is the angle by which the face of the tool is inclined towards back.

View solution

Q. As the cutting speed increases, tool life decreases.

View solution

Q. In metal machining, the work-tool contact zone is a zone where heat is generated due to

View solution

Q. Thread grinding requires work speed from

View solution

Q. Threading is an operation of

View solution

Q. The abrasive recommended for grinding materials of high tensile strength is

View solution

Q. The factor responsible for the formation of continuous chips with built up edge is

View solution