Q. A process of removing metal by pushing or pulling a cutting tool is called

View solution

Q. The hardness of a grinding wheel is specified by

View solution

Q. Which of the following operations can be performed with milling cutters?

View solution

Q. Crater wear is predominant in

View solution

Q. The method of centreless grinding used to produce taper is

View solution

Q. In a shaper, the length of stroke is increased by

View solution

Q. Carbon tool steels have low-heat and wear-resistance.

View solution

Q. Trepanning is an operation of

View solution

Q. While cutting helical gears on a non-differential gear hobber, the feed change gear ratio is

View solution

Q. The swing diameter over the bed is __________ the height of the centre measured from the bed of the lathe.

View solution

Q. In grinding irregular, curved, tapered, convex and concave surfaces, the grinder used is

View solution

Q. Down milling is also called

View solution

Q. Any number of equal divisions can be obtained on milling machine by

View solution

Q. The factor which affects the tool life is

View solution

Q. In lapping operaion, the amount of metal removed is

View solution

Q. The cutting force in up milling __________ per tooth movement of the cutter.

View solution

Q. The height of each tooth of a broach is

View solution

Q. A right hand tool on a lathe cuts most efficiently when it travels

View solution

Q. The trade name of a non-ferrous cast alloy composed of cobalt, chromium and tungsten is called

View solution

Q. In which of the following milling machine, the table can be tilted in a vertical plane by providing a swivel arrangement at the knee?

View solution