Q. Up milling is also called conventional milling.

View solution

Q. Fixtures are used

View solution

Q. In ultra-sonic machining, tool is made of

View solution

Q. Ceramic tools has greater tool life than carbide tools.

View solution

Q. The rake angle of a single point cutting tool corresponds to __________ of a twist drill.

View solution

Q. As the cutting speed increases, the tool cutting forces

View solution

Q. Crater wear leads to

View solution

Q. The addition of lead, sulphur and phosphorus to low carbon steels, help to

View solution

Q. The relation between the tool life (T) in minutes and cutting speed (V) in m/min is (where n = An exponent, which depends upon the tool and workpiece, and C = A constant)

View solution

Q. The width of cutting edge of a parting-off tool varies from

View solution

Q. A tool used to withdraw a drill from the sleeve is called

View solution

Q. The cutting fluid mostly used for machining steel is

View solution

Q. The lip angle is the angle

View solution

Q. Small nose radius

View solution

Q. The operation of producing grooves around the periphery of a cylindrical or conical workpiece is called

View solution

Q. The grinding wheel speed (surface speed in m/min) usually varies from

View solution

Q. The factor considered for evaluation of machinability is

View solution

Q. In oblique cutting system, the tool may or may not generate a surface parallel to the workface.

View solution

Q. The plunge grinding requires very __________ speed.

View solution

Q. In conventional milling, the cutting force tends to lift the work.

View solution