Q. The operation of machining several surfaces of a workpiece simultaneously is called

View solution

Q. The abrasive recommended for grinding materials of low tensile strength is

View solution

Q. The chamfering is an operation of

View solution

Q. The hard grade grinding wheels are denoted by the letters

View solution

Q. The tailstock set over required to turn a taper on the entire length of a workpiece having diameters D and d is

View solution

Q. The angle formed by the leading edge of the land with a plane having the axis of the drill, is called

View solution

Q. A drill bit of 20 mm diameter rotating at 500 r.p.m. with a feed rate of 0.2 mm/revolution is used to drill a through-hole in a mild steel plate 20 mm thickness. The depth of cut in this drilling operation is

View solution

Q. The tail stock and the carriage of a lathe may be guided on same or different guideway.

View solution

Q. In order to achieve a specific surface finish in single point turning, the most important factor to be controlled is

View solution

Q. Surface grinding is done to produce

View solution

Q. Gear finishing operation is called

View solution

Q. The tool life is said to be over if

View solution

Q. Continuous chips with built up edge are formed during machining of

View solution

Q. The rate of removing metal is __________ by increasing the depth of cut.

View solution

Q. The method of grinding used to produce internal cylindrical holes and tapers, is

View solution

Q. The tool life is __________ cutting speed.

View solution

Q. In drilling bakellite and fibrous plastics, the point angle of a drill is

View solution

Q. The shear velocity is the velocity of

View solution

Q. In centreless grinders, the regulating wheel is inclined at

View solution

Q. A grinding wheel is said to be of __________ if the abrasive grains can be easily dislodged.

View solution