Q. In a shaper, the metal is removed during

View solution

Q. The aluminium oxide abrasive is chiefly used for grinding

View solution

Q. In __________ operation, the chip thickness is minimum at the beginning of the cut and it reaches to the maximum when the cut terminates.

View solution

Q. In __________ operation, the cutting force is maximum when the tooth begins its cut and reduces it to minimum when the tooth leaves the work.

View solution

Q. The taper on the lathe spindle is

View solution

Q. In machining cast iron, no cutting fluid is required.

View solution

Q. In machining metals, surface roughness is due to

View solution

Q. A diamond locating pin is used in jigs and fixtures because

View solution

Q. In metal machining, the zone where the heat is generated due to friction between the moving chip and the tool face, is called

View solution

Q. The drill spindles are provided with standard taper known as

View solution

Q. The dressing and truing of grinding wheel are done with the same tools but not for the same purpose.

View solution

Q. The point angle of a drill, for drilling stainless steel, is

View solution

Q. A numerical method of identification of tool is known as tool signature.

View solution

Q. Tumbler gears in lathe are used to

View solution

Q. The operation performed on a shaper is

View solution

Q. Chemical milling operation is performed

View solution

Q. The thrust force will increase with the increase in

View solution

Q. The broaching operation in which the work moves past the stationary tool is called

View solution

Q. In transverse grinding

View solution

Q. Jigs are heavier than fixtures in construction.

View solution