Q. A load which is spread over a beam in such a manner that it varies uniformly over the whole length of abeam is called uniformly __________ load.

View solution

Q. Which of the following statement is correct?

View solution

Q. The bending moment at a point on a beam is the algebraic __________ of all the moments on either side of the point.

View solution

Q. The maximum diameter of the hole that can be punched from a plate of maximum shear stress 1/4th of its maximum crushing stress of punch, is equal to (where t = Thickness of the plate)

View solution

Q. Two closely coiled helical springs 'A' and 'B' are equal in all respects but the number of turns of spring 'A' is half that of spring 'B' The ratio of deflections in spring 'A' to spring 'B' is

View solution

Q. The deformation per unit length is called

View solution

Q. In order to know whether a column is long or short, we must know its slenderness ratio.

View solution

Q. A composite shaft consisting of two stepped portions having spring constants k1 and k2 is held between two rigid supports at the ends. Its equivalent spring constant is

View solution

Q. Resilience is the

View solution

Q. If the depth is kept constant for a beam of uniform strength, then its width will vary in proportional to (where M = Bending moment)

View solution

Q. A concentrated load is one which

View solution

Q. If the slenderness ratio for a column is 100, then it is said to be a __________ column.

View solution

Q. A masonry dam may fail due to

View solution

Q. In order to prevent crushing of masonry at the base of the dam, the maximum stress should be __________ the permissible stress of the soil.

View solution

Q. When a body is subjected to two equal and opposite pushes, as a result of which the body tends to reduce its length, the stress and strain induced is compressive.

View solution

Q. Strain energy is the

View solution

Q. A vertical column has two moments of inertia (i.e. Ixx and Iyy ). The column will tend to buckle in the direction of the

View solution

Q. The neutral axis of the cross-section a beam is that axis at which the bending stress is

View solution

Q. Euler's formula holds good only for

View solution

Q. The object of caulking in a riveted joint is to make the joint

View solution