Q. For a 25 mm hole drilled in plates, the diameter of rivet shank should be

View solution

Q. A beam of uniform strength has

View solution

Q. The shear force of a simply supported beam carrying a central point load changes sign at its midpoint.

View solution

Q. In a simple bending theory, one of the assumption is that the material of the beam is isotropic. This assumption means that the

View solution

Q. The Poisson's ratio for cast iron varies from

View solution

Q. The Rankine's theory for active earth pressure is based on the assumption that

View solution

Q. The strain energy stored in a spring, when subjected to maximum load, without suffering permanent distortion, is known as

View solution

Q. An overhanging beam must overhang on both sides.

View solution

Q. The resultant stress on an inclined plane which is inclined at an angle θ to the normal cross-section of a body which is subjected to a direct tensile stress (σ) in one plane, is

View solution

Q. The slenderness ratio is the ratio of

View solution

Q. When two shafts of same length, one of which is hollow, transmit equal torques and have equal maximum stress, then they should have equal

View solution

Q. According to Euler's column theory, the crippling load for a column of length (l) fixed at both ends is __________ the crippling load for a similar column hinged at both ends.

View solution

Q. The ratio of change in volume to the original volume is called

View solution

Q. In a beam where shear force changes sign, the bending moment will be

View solution

Q. The maximum shear stress of a beam of triangular section occurs above the neutral axis,

View solution

Q. The ductility of a material __________ with the increase in percentage reduction in area of a specimen under tensile test.

View solution

Q. The bending moment in the centre of a simply supported beam carrying a uniformly distributed load of w per unit length is

View solution

Q. When a thin cylindrical shell is subjected to an internal pressure, there will be

View solution

Q. A welded joint as compared to a riveted joint has __________ strength.

View solution

Q. The shear force at apoint on a beam is the algebraic __________ of all the forces on either side of the point.

View solution