Q. When a beam is subjected to a bending moment, the strain in a layer is __________ the distance from the neutral axis.

View solution

Q. The thermal or temperature stress is a function of

View solution

Q. The breaking stress is __________ the ultimate stress.

View solution

Q. A bolt is made to pass through a tube and both of them are tightly fitted with the help of washers and nuts. If the nut is tightened, then

View solution

Q. A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The minimum normal stress will be

View solution

Q. Which of the following statement is correct?

View solution

Q. In watches, the spring is used to absorb shocks and vibrations.

View solution

Q. The polar moment of inertia of a solid circular shaft of diameter (D) is

View solution

Q. The volumetric strain is the ratio of the

View solution

Q. A thin cylindrical shell of diameter (d), length (l) and thickness (t) is subjected to an internal pressure (p). The ratio of longitudinal strain to hoop strain is

View solution

Q. A simply supported beam of length l is loaded with a uniformly distributed load of w per unit length. The maximum deflection is and lies at the centre of the beam.

View solution

Q. In a thick cylindrical shell subjected to an internal pressure (p), the tangential stress across the thickness of a cylinder is

View solution

Q. A bar of copper and steel form a composite system, which is heated to a temperature of 40°C. The stress induced in the copper bar will be

View solution

Q. Two closely-coiled helical springs 'A' and 'B' of the same matenal, same number of turns and made from same wire are subjected to an axial load W. The mean diameter of spring 'A' is double the mean diameter of spring 'B'. The ratio of deflections in spring 'B' to spring 'A' will be

View solution

Q. Two shafts 'A' and 'B' have the same material. The shaft 'A' is solid of diameter 100 mm. The shaft 'B' is hollow with outer diameter 100 mm and inner diameter 50 mm. The torque transmitted by shaft 'B' is __________ as that of shaft 'A'.

View solution

Q. The tensile strength of the welded joint for double fillet is (where s = Leg or size of the weld, l = Length of weld, and σt = Allowable tensile stress for weld metal)

View solution

Q. The direct stress, across a principal plane, is known as principal stress.

View solution

Q. On one side of a neutral axis of a beam, there is a tensile stress and on the other side of the beam there is a compressive stress.

View solution

Q. When a body is subjected to a direct tensile stress (σ), the maximum normal stress is equal to the direct tensile stress.

View solution

Q. A reinforced cement concrete beam is considered to be made of

View solution