Q. Young's modulus may be defined as the ratio of

View solution

Q. The maximum shear stress in a thin cylindrical shell subjected to internal pressure p is

View solution

Q. When a shaft, is subjected to torsion, the shear stress induced in the shaft varies from

View solution

Q. The maximum bending moment for a simply supported beam with a gradually varying load from zero at both ends and w per metre at the centre, lies at the centre of a beam.

View solution

Q. A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The maximum shear stress will be

View solution

Q. A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to

View solution

Q. The factor of safety is always more than unity.

View solution

Q. Mohr's circle is used to determine the stresses on an oblique section of a body subjected to

View solution

Q. The proof resilience is the maximum strain energy which can be stored in a body.

View solution

Q. The maximum shear stress developed in a beam of rectangular section is __________ the average shear stress.

View solution

Q. The strength of a riveted joint is equal to the

View solution

Q. The neutral axis of the symmetrical beam does not pass through the centroid of the beam.

View solution

Q. The Poisson's ratio for steel varies from

View solution

Q. The deformation of a bar under its own weight is __________ the deformation, if the same body is subjected to a direct load equal to weight of the body.

View solution

Q. Which of the following statement is correct?

View solution

Q. When a bar of length l, width b and thickness t is subjected to a push of P, its

View solution

Q. If the magnitude of direct stress and bending stress is equal, then there will be zero stress at one of the extreme ends of a column.

View solution

Q. When a thin cvlindrical shell is subjected to an internal pressure, the volumetric strain is (where ε1 = Hoop strain, and ε2 = Longitudinal strain)

View solution

Q. In a riveted joint, when the rivets in.the adjacent rows are staggered in such a way that every rivet is in the middle of the two rivets of the opposite row, the joint is said to be diamond riveted.

View solution

Q. In a simple bending theory, one of the assumption is that the plane sections before bending remain plane after bending. This assumption means that

View solution