Q. If there is a fall in the temperature of a composite body, then a member having greater coefficient of linear expansion will be subjected to compressive stress.

View solution

Q. A section of beam is said to be in pure bending, if it is subjected to

View solution

Q. When a body is subjected to two equal and opposite forces, acting tangentially across the resisting section, as a result of which the body tends to shear off across the section, the stress and strain induced is

View solution

Q. The perpendicular distance between the centre lines of the successive rows, is called pitch.

View solution

Q. The values of equivalent length (L) and actual length (l) of a column for both ends hinged is the same

View solution

Q. The actual neutral axis of a reinforced cement concrete beam is based on the principle that the moment of areas of compression and tension zones at the neutral axis are equal.

View solution

Q. A cantilever beam is one which is

View solution

Q. In the above question, the ratio of stiffness of spring 'B' to spring 'A' will be

View solution

Q. The neutral axis of a transverse section of a beam passes through the centre of gravity of the section and is

View solution

Q. The distance between the centre of a rivet hole to the nearest edge of plate, is called

View solution

Q. A localised compressive stress at the area of contact between two members is known as

View solution

Q. Two closely-coiled helical springs 'A' and 'B' are equal in all respects but the number of turns of spring 'A' is double that of spring 'B'. The stiffness of spring 'A' will be __________ that of spring 'B'.

View solution

Q. In a tensile test, when the material is stressed beyond elastic limit, the tensile strain __________ as compared to the stress.

View solution

Q. Poisson's ratio is the ratio of linear stein to the volumetric strain.

View solution

Q. The product of Young's modulus (E) and moment of inertia (I) is known as

View solution

Q. The relation between equivalent length (L) and actual length (l) of a column for both ends fixed is

View solution

Q. The ratio of maximum shear stress developed in a rectangular beam and a circular beam of the same cross-sectional area is

View solution

Q. Transverse fillet welds are designed for

View solution

Q. The planes, which carry no shear stress, are known as principal planes.

View solution

Q. The stiffness of a closely-coiled helical spring is __________ proportional to number of turns.

View solution