Q. When a bar is subjected to a change of temperature and its deformation is prevented, the stress induced in the bar is

View solution

Q. A shear stress across a plane, is always accompanied by a balancing shear stress across the plane and normal to it.

View solution

Q. The bending moment diagram for a simply supported beam loaded in its centre is

View solution

Q. A load which acts at a point on a beam is not called uniformly distributed load.

View solution

Q. The rectangular beam 'A ' has length l, width b and depth d. Another beam 'B' has the same width and depth but length is double that of 'A'. The elastic strength of beam 'B' will be __________ as compared to beam A.

View solution

Q. A tensile test is performed on a round bar. After fracture, it has been found that the diameter remains approximately same at fracture. The material under test was

View solution

Q. In a simply supported beam carrying a uniformly distributed load w per unit length, the point of contraflexure

View solution

Q. Modulus of rigidity may be defined as the ratio of

View solution

Q. A body is subjected to a direct tensile stress of 300 MPa in one plane accompanied by a simple shear stress of 200 MPa. The maximum normal stress will be

View solution

Q. A simply supported beam 'A' of length l, breadth b, and depth d carries a central point load W. Another beam 'B' has the same length and depth but its breadth is doubled. The deflection of beam 'B' will be __________ as compared to beam 'A'.

View solution

Q. The moment of resistance of a balanced reinforced concrete beam is based on the stresses in

View solution

Q. The load at which the column just buckles, is known as

View solution

Q. The Rankine's constant for a mild steel column with both ends hinged is

View solution

Q. The relation between equivalent length (L) and actual length (l) of a column for one end fixed and the other end hinged is

View solution

Q. The total strain energy stored in a body is called proof resilience.

View solution

Q. The thermal stress in a bar is __________ proportional to the change in temperature.

View solution

Q. The section modulus of a circular section about an axis through its C.G., is

View solution

Q. In the above question, the normal stress on an oblique section will be maximum, when θ is equal to

View solution

Q. The strain energy stored in a body, when suddenly loaded, is __________ the strain energy stored when same load is applied gradually.

View solution

Q. The shear force at the centre of a simply supported beam with a gradually varying load from zero at both ends to w per metre at the centre, is

View solution