Q. A body is subjected to a direct tensile stress of 300 MPa in one plane accompanied by a simple shear stress of 200 MPa. The minimum normal stress will be

View solution

Q. The polar modulus for a hollow shaft of outer diameter (D) and inner diameter (d) is

View solution

Q. The ratio of linear stress to the linear strain is called

View solution

Q. A riveted joint may fail by

View solution

Q. Which of the following is a proper sequence?

View solution

Q. The neutral axis of a beam is subjected to __________ stress.

View solution

Q. When a load on the free end of a cantilever beam is increased, failure will occur

View solution

Q. The length of a conical bar is l, diameter of base is d and weight per unit volume is w. It is fixed at its upper end and hanging freely. The elongation of the bar under the action of its own weight will be

View solution

Q. A pressure vessel is said to be a thin shell when the ratio of wall thickness of the vessel to its diameter is __________ 1/10.

View solution

Q. According to Euler's column theory, the crippling load of a column is given by p = π2 EI/Cl2. In the Euler's formula, the value of C for a column with one end fixed and the other end hinged, is 1/2.

View solution

Q. A tensile test is performed on a mild steel round bar. Its diameter after fracture will

View solution

Q. Two closely coiled helical springs 'A' and 'B' are equal in all respects but the diameter of wire of spring 'A' is double that of spring 'B' The stiffness of spring 'B' will be __________ that of spring 'A'

View solution

Q. When a closely-coiled helical spring of mean diameter (D) is subjected to an axial load (W), the stiffness of the spring is given by

View solution

Q. A leaf spring is supported at the

View solution

Q. In leaf springs, the maximum bending stress developed in the plates is (where W = Load acting on the spring, l = Span of the spring, n = Number of plates, b = Width of plates, and t = Thickness of plates)

View solution

Q. The unit of stress in S.I. units is

View solution

Q. The modulus of elasticity for mild steel is approximately equal to

View solution

Q. The Rankine's formula holds good for

View solution

Q. The strain energy stored in a body due to shear stress, is (where τ = Shear stress, C = Shear modulus, and V = Volume of the body)

View solution

Q. In case of eccentrically loaded struts __________ is preferred.

View solution