Question
a.
Agree
b.
Disagree
c.
Can't say
d.
None of these
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. When the speed of the pump increases, its net positive suction head (NPSH) requirement decreases.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The speed of a turbine runner is
View solution
Q. Discharge of a centrifugal pump is (where N = Speed of the pump impeller)
View solution
Q. In a reaction turbine, the draft tube is used
View solution
Q. The power produced by the reaction turbine is __________ to the head of water.
View solution
Q. In an inward flow reaction turbine
View solution
Q. The working of which of the following hydraulic units is based on Pascal's law?
View solution
Q. The hydraulic efficiency of a reaction turbine, is the ratio of
View solution
Q. In order to avoid cavitation in centrifugal pumps
View solution
Q. A hydraulic intensifier is a device used to increase the intensity of pressure of water by means of energy available from a large quantity of water at a low pressure.
View solution
Q. By fitting an air vessel to the reciprocating pump, there is always a saving of work done and subsequently saving of power.The saving in case of a double acting reciprocating pump is
View solution
Q. In a reciprocating pump, air vessels are used to
View solution
Q. In a Francis turbine, the pressure at inlet is __________ that at outlet.
View solution
Q. If the ratio's of the corresponding forces acting at corresponding points are equal, then the model and the prototype are said to have.
View solution
Q. A Pelton wheel working under a constant head and discharge, has maximum efficiency when the speed ratio is
View solution
Q. The impeller of a centrifugal pump may have
View solution
Q. Kinematic similarity is said to exist between the model and the prototype, if both of them
View solution
Q. Power required (in watts) to drive a centrifugal pump is (where Hm = Manometric head in metres, w = Specific weight in N/m³, Q = Discharge of the pump in m³/s, and ηo = Overall efficiency of the pump)
View solution
Q. A reciprocating pump is suitable for less discharge and higher heads.
View solution
Q. The flow ratio of Francis turbine is defined as the ratio of the
View solution
Q. The depth of the bucket for a Pelton wheel is generally __________ the diameter of jet.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
