Q. A jet of water enters and leaves a fixed curved vane tangentially. The force of jet along perpendicular to the vane is zero.

View solution

Q. In a mixed flow centrifugal pump, the flow through the impeller is a combination of radial and axial flows.

View solution

Q. A Pelton wheel is

View solution

Q. The discharge through a reaction turbine __________ with the increase in unit speed.

View solution

Q. In a mixed flow reaction turbine, the flow of water is partly radial and partly axial.

View solution

Q. A Pelton wheel with one nozzle is preferred for a specific speed between 35 to 60 r.p.m.

View solution

Q. Which of the following pump is generally used to pump highly viscous fluid?

View solution

Q. The overall efficiency of an impulse turbine is the ratio of the actual power produced by the turbine to the energy actually supplied by the turbine.

View solution

Q. By fitting an air vessel to the reciprocating pump, there is always a saving of work done and subsequently saving of power. This saving in case of a single acting reciprocating pump is

View solution

Q. If the Francis turbine is run below 50 percent head for a long period, it will not only lose its efficiency but also the cavitation danger will become more serious.

View solution

Q. The maximum hydraulic efficiency of an impulse turbine is (where φ = Angle of blade tip at outlet)

View solution

Q. In a Francis turbine runner, the number of blades are generally between

View solution

Q. The relation between hydraulic efficiency (ηh), mechanical efficiency (ηm) and overall efficiency (ηo) ) is

View solution

Q. In a centrifugal pump, the water enters the impeller __________ and leaves the vanes axially.

View solution

Q. A Kaplan turbine is an axial flow reaction turbine.

View solution

Q. A Pelton wheel develops 1750 kW under a head of 100 metres while running at 200 r.p.m. and discharging 2500 litres of water per second. The unit speed of the wheel is

View solution

Q. The hydraulic efficiency of an impulse turbine is maximum when velocity of wheel is __________ of the jet velocity,

View solution

Q. The specific speed of a hydraulic turbine depends upon

View solution

Q. Dynamic similarity is said to exist between the model and the prototype, if both of them

View solution

Q. The specific speed of a turbine is given by the equation

View solution