Question

The chimney draught varies with

a.

climatic conditions

b.

temperature of furnace gases

c.

height of chimney

d.

all of these

Posted under Mechanical Engineering

Answer: (d).all of these

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The chimney draught varies with

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Benson boiler requires

Q. The high pressure and low pressure cylinders in a Tandem type compound engine are regarded as having cranks

Q. The amount of water evaporated or steam produced in kg per kg of fuel burnt is known as power of a boiler.

Q. The fire tubes in a Cochran boiler usually have __________ diameter.

Q. Cut-off governing as compared to throttle governing is

Q. A compound steam engine in which piston rods of high pressure and low pressure cylinders ' are attached to two different cranks set at 180° to each other, is called

Q. The heat balance sheet for the boiler shows the

Q. The performance of a boiler is measured by the

Q. The evaporative capacity of a boiler is defined as the evaporation of 15.653 kg of water per hour from and at 100° C.

Q. The maximum heat loss is a boiler occurs due to

Q. For maximum discharge through a chimney, the temperature of flue gases inside the chimney should the slightly more than the atmospheric temperature.

Q. The internal flue tubes of a Lancashire boiler are reduced in diameter at the back to provide access to the lower part of the boiler.

Q. A device in which some portion of waste heat of flue gases is recovered to heat the air before it passes to the furnace for combustion purpose, is knwon as

Q. In a fire tube boiler, the water is contained inside the tubes which are surrounded by flames and hot gases from outside.

Q. Steam engines are called external combustion engines.

Q. The diagram factor is the ratio of the

Q. By compounding the expansion of steam in two or more cylinders, the length of stroke

Q. The velocity of flue gases (V) through the chimney under a static draught of(H') metres is given by

Q. A good steam boiler is one which produces maximum quantity of steam with the given fuel

Q. Cut-off ratio is the ratio of

Recommended Subjects

Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!