Question

In a compound steam engine, the temperature range per cylinder is reduced, with corresponding reduction in the condensation.

a.

Correct

b.

Incorrect

c.

Can't say

d.

None of these

Posted under Mechanical Engineering

Answer: (a).Correct

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In a compound steam engine, the temperature range per cylinder is reduced, with corresponding reduction in the condensation.

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Willian's law holds good for throttle-governed engine, but not for cut-off governed engine.

Q. Which of the following is required for a steam condensing plant ?

Q. The missing quantity is mainly due to cylinder condensation and a small amount of steam leakage past the valves and piston.

Q. There is always some steam left in the clearance space from the previous stroke. This steam left in the clearance space is called

Q. The ratio of the volume at cut-off to the swept volume is called

Q. The factor of evaporation for all boilers is always

Q. The ratio of the actual vacuum to the ideal vacuum in a condenser is called

Q. The draught (in mm of water), for maximum discharge of flue gases through the chimney, is given by (where H = Height ot the chimney in metres, and T1 = Absolute temperature of air outside the chimney in K)

Q. An air preheater

Q. A condenser in a steam power plant

Q. Willian's law states that the steam consumption per hour provided with a throttled governor is proportional to (where I.P. = Indicated power)

Q. A condenser where circulating water flows through tubes which are surrounded by steam, in known as

Q. Combustuion of fuel takes place __________ the engine cylinder of a steam engine.

Q. The forced circulation of water does not take place in

Q. A device used to heat feed water by utilising the heat in me exhaust flue gases before leaving through the chimny, is known as

Q. When the circulation of water, in a boiler, is by convection currents which are set up during the heating of water, then the boiler is known as

Q. The ratio of heat equivalent to brake power to the energy supplied in steam is known as

Q. When the speed of the engine is controlled by means of a valve in a steam pipe, which regulates the pressure of steam entering the engine, then the governing is known as

Q. The length of Lancashire boiler varies from

Q. The ratio of brake power to the indicated power is known as

Recommended Subjects

Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!