Question

For maximum discharge through a chimney, the condition is that height of hot gas column producing the draught should be

a.

one-half the height of chimney

b.

equal to the height of chimney

c.

two times the height of chimney

d.

four times the height of chimney

Posted under Mechanical Engineering

Answer: (b).equal to the height of chimney

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. For maximum discharge through a chimney, the condition is that height of hot gas column producing the draught should be

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Water tube boilers are

Q. Which of the following is correct ? (where pa = Actual mean effective pressure, pm = Theoretical mean effective pressure, and K = Diagram factor)

Q. The working pressure range for a La-Mont boiler is

Q. The draught in locomotive boilers is produced by a

Q. The ratio of heat actually used in producing the steam to the heat liberated in the furnace is known as equivalent evaporation from and at 100° C.

Q. There is about 15 to 20% of coal saving when an economiser is used in a boiler.

Q. The principal function of a stop valve is to

Q. The length of Cornish boiler varies from

Q. The indicated thermal efficiency is defined as the

Q. In surface condensers, the condensate and the cooling water mixes up.

Q. A water level indicator is a device to indicate the exact water level in the boiler at any instant.

Q. Which of the following statement is correct ?

Q. Which of the following compound steam engine requires a smaller flywheel ?

Q. An economiser is generally placed between

Q. In fire tube boilers

Q. The efficiency of a boiler is defined as

Q. The ratio of the temperature rise of cooling water to the vacuum temperature minus inlet cooling water temperature is called

Q. A valve installed between the boiler and the feed pump is

Q. A vessel into which the steam is exhausted and condensed after doing work in an engine cylinder or turbine is known as

Q. The value of diagram factor depends upon

Recommended Subjects

Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!