Q. The endurance limit for a mirror polished material will be __________ as compared to unpolished material.

View solution

Q. A sliding bearing which operates without any lubricant present, is called

View solution

Q. The material used for brake lining should have __________ coefficient of friction.

View solution

Q. A steel containing more than 0.8% carbon is known as eutectoid steel.

View solution

Q. In leaf springs, the longest leaf is known as

View solution

Q. The taper on cotter varies from

View solution

Q. Which of the following screw thread is used for power transmission in one direction only.

View solution

Q. When the bearing is subjected to large fluctuations of load and heavy impacts, the bearing characteristic number should be __________ the bearing modulus.

View solution

Q. Screws jacks have multiple threads.

View solution

Q. In an ordinary bolt, the effect of the impulsive loads applied axially is concentrated on the cross-sectional area at the root of the threads.

View solution

Q. The radial distance of a tooth from the pitch circle to the top of the tooth is called

View solution

Q. In a gear, having involute teeth, the normal to the involute is a tangent to the

View solution

Q. Which of the following statement is correct ?

View solution

Q. When a shaft is subjected to combined twisting moment (T) and bending moment (M), then the equivalent twisting moment is equal to

View solution

Q. In helical gears, the right hand helixes on one gear will mesh __________ helixes on the other gear.

View solution

Q. A connecting rod is designed as a

View solution

Q. The cross-section of the arm of a bell crank lever is

View solution

Q. The rocker arms in internal combustion engines are of first type levers.

View solution

Q. A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be

View solution

Q. The longitudinal stress is __________ of the circumferential stress.

View solution