Q. In order to withstand resistance to wear, the best profile of gear is

View solution

Q. Which of the following has threads at both ends?

View solution

Q. The ratio of the ultimate stress to the design stress is known as

View solution

Q. According to Indian standards, the diameter of rivet hole is made larger than the basic size of rivet by

View solution

Q. The cam follower extensively used in air-craft engines is

View solution

Q. The minor diameter of a screw thread is also known as outside or nominal diameter.

View solution

Q. The effective stress in wire ropes during normal working is equal to the stress due to

View solution

Q. When the length of the journal is equal to the diameter of the journal, then the bearing is said to be a

View solution

Q. A connecting rod should be

View solution

Q. According to I.B.R., the efficiency of a triple riveted butt joint with double straps of unequal width (5 rivets per pitch length) should be

View solution

Q. When two non-parallel or intersecting but coplaner shafts are connected by gears, the arrangement is known as bevel gearing.

View solution

Q. A tapered key which fits in a key way in the hub and the bottom of which is shaped to fit the curved surface of the shaft, is known as hollow saddle key.

View solution

Q. In levers, leverage is the ratio of

View solution

Q. The diameter of washer is generally taken bigger than the nut size.

View solution

Q. Which of the following statement is wrong?

View solution

Q. If a shaft made from ductile material is subjected to combined bending and twisting moment, calculations based on which one of the following failure theories will give the most conservative value?

View solution

Q. The velocity factor for precision metallic gears cut with high accuracy and operating at velocities upto 20 m/s is equal to

View solution

Q. In a bolt, the plane of shear should be across the threaded portion of the shank.

View solution

Q. When a metal or alloy is cold worked,

View solution

Q. A leaf spring in automobiles is used

View solution