Q. For circumferential joint in boilers, the type of joint used is

View solution

Q. In cyclic loading, stress concentration is more serious in

View solution

Q. For a square key made of mild steel, the shear and crushing strength are related as

View solution

Q. According to Rankine's theory, the failure occurs at a point in a member

View solution

Q. The dedendum is the radial distance from the

View solution

Q. In a steam engine, the valve rod is connected to an eccentric rod by means of

View solution

Q. In helical gears, the distance parallel to the axis, between similar faces of adjacent teeth, is called

View solution

Q. Which of the following property is desirable in parts subjected to shock and impact loads?

View solution

Q. In block brakes, the ratio of shoe width to wheel diameter is taken between

View solution

Q. Oldham coupling is used to transmit power between two parallel shafts which are slightly offset.

View solution

Q. A shaft is subjected to fluctuating loads for which the normal torque (T) and bending moment (M) are 1000 N-m and 500 N-m respectively. If the combined shock and fatigue factor for bending is 1.5 and combined shock and fatigue factor for torsion is 2, then the equivalent twisting moment for the shaft is

View solution

Q. When a machine member is subjected to torsion, the torsional shear stress set up in the member is

View solution

Q. If the centre distance of the mating gears having involute teeth is increased, then the pressure angle

View solution

Q. In cylindrical cams, the follower moves

View solution

Q. The included angle for the acme thread is 29°.

View solution

Q. The process extensively used for making bolts and nuts is

View solution

Q. In a transverse fillet welded joint, the size of weld is __________ the throat of weld.

View solution

Q. In the levers of first type, the mechanical advantage is __________ one.

View solution

Q. The load placed at the top of the screw in a mechanical screw jack is prevented from rotation by providing a swivelling mechanism.

View solution

Q. The usual proportion for the width of key is (where d = Diameter of shaft or diameter of hole in the hub)

View solution