Q. A turn buckle is used to connect two round rods subjected to tensile loading and requiring subsequent adjustment for tightening or loosening.

View solution

Q. The plasticity is the property of a material which enables it to

View solution

Q. An open coiled helical compression spring 'A' of mean diameter 50 mm is subjected to an axial load W. Another spring 'B' of mean diameter 25 mm is similar to spring 'A' in all respects. The deflection of spring 'B' will be __________ as compared to spring 'A'.

View solution

Q. When the bolt is very yielding as compared to the connected members, then the resultant load on the bolt will be equal to the

View solution

Q. During hot working of metals,

View solution

Q. The velocity factor for very accurately cut and ground metallic gears operating at velocities upto __________ is equal to 6/6 + v.

View solution

Q. The power transmitted by means of a belt depends upon

View solution

Q. Which of the following coupling is used to connect two shafts which have both lateral and angular misalignment ?

View solution

Q. In a multiple V-belt drive, when a single belt is damaged, it is preferable to change the complete set in order to

View solution

Q. A steel containing 0.8% carbon is known as

View solution

Q. Guest's theory is used for

View solution

Q. The square threads are usually found on

View solution

Q. For general industrial machinery, the ratio of the length of journal to its diameter is taken as

View solution

Q. The spring mostly used in gramophones is

View solution

Q. A saddle key __________ power through frictional resistance only.

View solution

Q. A rivet is specified by

View solution

Q. In thrust bearings, the load acts

View solution

Q. Auto frettage is the method of

View solution

Q. According to Indian standard specifications, a grey cast iron designated by 'FG 200' means that the

View solution

Q. When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor, and W = Axial compressive load on the spring)

View solution