Q. The included angle for the V-belt is usually

View solution

Q. In static loading, stress concentration is more serious in

View solution

Q. The bending stress in a curved beam is

View solution

Q. The piston pin bearings in heavy duty diesel engines are

View solution

Q. Cast iron pipes are mainly used

View solution

Q. In a multiple V-belt drive, if one of the belts break, then

View solution

Q. The steel pulleys are __________ in weight than cast iron pulleys of the same capacity.

View solution

Q. The parallel fillet welded joints are designed for compressive strength.

View solution

Q. A column of length l is fixed at both ends. The equivalent length of the column is

View solution

Q. A spring of stiffness 1000 N/m is streteched initially by 100 mm from the undeformed position. The work required to stretch it by another 100 mm is

View solution

Q. A feather key transmits a turning moment and permits axial movement also.

View solution

Q. The width of the pulley should be __________ width of the belt.

View solution

Q. In a boundary lubricated bearing, there is a __________ of lubricant between the journal and the bearing.

View solution

Q. The design of the pressure vessel is based on

View solution

Q. A spring is used to

View solution

Q. When the top of a tooth undercuts the root on the mating gear, it is known as interference.

View solution

Q. If the helix angle of a helical gear is increased, the load carrying capacity of the tooth increases.

View solution

Q. The expansion joint is mostly used for pipes which carry steam at __________ pressures.

View solution

Q. A compound belt drive is used when

View solution

Q. In order to have smooth operation, the minimum number of teeth on the smaller sprocket, for moderate speeds, should be

View solution