Question
a.
p.d.σc
b.
p.t.σc
c.
n.d.t.σc
d.
(p - d)t.σc
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Crushing resistance required to crush the rivet per pitch length is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d = Dia. of rivet hole, and σt = Permissible tensile stress for plate material)
View solution
Q. The buttress threads have low frictional resistance characteristic of the square threads and have the same strength of V-threads.
View solution
Q. The tension on the slack side of the belt is __________ the tension on the tight side of the belt.
View solution
Q. The property of a material which enables it to resist fracture due to high impact loads, is called toughness.
View solution
Q. The resultant axial load on a bolt depends upon
View solution
Q. Wire ropes as compared to cotton ropes
View solution
Q. The thickness of key is usually taken equal to one-sixth of diameter of shaft.
View solution
Q. Two helical springs of the same material and of equal circular cross-section, length and number of turns, but having radii 80 mm and 40 mm, kept concentrically (smaller radius spring within the larger radius spring), are compressed between two parallel planes with a load W. The inner spring will carry a load equal to
View solution
Q. A key is normally made from a cold rolled mild steel bars.
View solution
Q. Which of following statement is correct, for the two shafts connected in parallel?
View solution
Q. Lewis form factor for the 20° full depth involute system is equal to 0.154 - 0.841/T.
View solution
Q. The railway carriage couplings have
View solution
Q. A shaft is subjected to
View solution
Q. The strength of a riveted joint is equal to
View solution
Q. When a shaft is subjected to combined twisting moment (T) and bending moment (M), then the equivalent bending moment is equal to
View solution
Q. When a helical compression spring is cut into halves, the stiffness of the resulting spring will be
View solution
Q. The transverse fillet welded joints are designed for
View solution
Q. The centrifugal tension in the belt
View solution
Q. According to Clavarino's equation, the thickness of a cylinder is equal to (where d = Inner diameter of cylinder, p = Internal pressure, and μ = Poisson's ratio. )
View solution
Q. When an open coiled helical compression spring is subjected to an axial load (W), the compression produced in the spring will be (where n = No. of active turns of the spring, and G = Modulus of rigidity for the spring material)
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!