Q. In vibration isolation system, if ω/ωn < 2, then for all values of damping factor, the trans-missibility will be (where ω = Angular speed of the system, ωn = Natural frequency of vibration of the system)

View solution

Q. When a point at the end of a link moves with constant angular velocity, its acceleration will have

View solution

Q. The time taken by a particle for one complete oscillationis known as periodic time.

View solution

Q. The danger of breakage and vibration is maximum

View solution

Q. The primary unbalanced force due to inertia of reciprocating parts in a reciprocating engine is given by (where m = Mass of reciprocating parts, ω = Angular speed of crank, r = Radius of crank, θ = Angle of inclination of crank with the line of stroke, and n = Ratio of the lengm of connecting rod to radius of crank)

View solution

Q. For two governors A and B, the lift of sleeve of governor A is more than that of governor B, for a given fractional change in speed. It indicates that

View solution

Q. The component of the acceleration, parallel to the velocity of the particle, at the given instant is called

View solution

Q. In a multiple V-belt drive, if one of the belt is broken, then we should replace

View solution

Q. Most of the engines, generally, do not require balancing of secondary forces and couples.

View solution

Q. The secondary unbalanced force is maximum __________ in one revolution of the crank.

View solution

Q. A spring controlled governor is found unstable. It can be made stable by

View solution

Q. In order to have a good grip on the pulley, the V-belt should touch the bottom of the groove in the pulley.

View solution

Q. In order to double the period of a simple pendulum, the length of the string should be

View solution

Q. When a slider moves on a fixed link having curved surface, their instantaneous centre lies

View solution

Q. Scotch yoke mechanism is used to generate

View solution

Q. The unbalanced primary forces in a reciprocating engine are

View solution

Q. The balancing of a rigid rotor can be achieved by appropriately placing balancing masses in

View solution

Q. The frictional torque transmitted in a conical pivot bearing with assumption of uniform pressure is __________ as compared to uniform wear.

View solution

Q. In a cam drive with uniform velocity follower, the sharp corners of the displacement diagram are rounded off at the beginning and at the end of each stroke. This is done

View solution

Q. In a steam engine, the earlier cut-off with a simple slide valve may be obtained by increasing the angle of advance of the eccentric but reducing the throw of the eccentric and keeping the steam lap and exhaust lap constant. This method will cause withdrawing or throttling of steam.

View solution