Q. The maximum fluctuation of speed is the

View solution

Q. A single degree of freedom system is given by , with usual notations. It represents

View solution

Q. In a Hartnell governor, the lift of the sleeve is given by (where r1 and r2 = Max. and min. radii of rotation, x = Length of ball arm of the lever, and y = Length of sleeve arm of the lever)

View solution

Q. When a mechanism is required to transmit power or to do some particular type of work, then it becomes a machine.

View solution

Q. The transmissibility, for all values of damping factor, will be less than unity, if ω/ωn is

View solution

Q. When a shaking force is transmitted through the springs, damping becomes detrimental when the ratio of its frequency to the natural frequency is greater than

View solution

Q. When the nature of contact between the elements of a pair is such that it can turn or revolve about a fixed axis, the pair is known as a rolling pair.

View solution

Q. Creep in belt drive is due to

View solution

Q. Which of the following statement is wrong?

View solution

Q. A watt's governor can work satisfactorily at speeds from

View solution

Q. The displacement of a flat-faced follower when it has contact with the flank of a circular arc cam, is given by (where R = Radius of flank, r1 = Minimum radius of the cam, and θ = Angle turned through by the cam)

View solution

Q. The contact ratio is the ratio of

View solution

Q. An exact straight line motion mechanism is a

View solution

Q. A body of weight W is required to move up the rough inclined plane whose angle of inclination with the horizontal is α. The effort applied parallel to the plane is given by (where μ = tan φ = Coefficient of friction between the plane and the body)

View solution

Q. In vibration isolation system, if ω/ωn > 2, then for all values of damping factor, the trans-missibility (i.e. the ratio of the force transmitted to the force applied) will be less than unity.

View solution

Q. The acceleration of the reciprocating roller follower when it has contact with the straight flanks of the tangent cam, is given by

View solution

Q. In a four bar chain or quadric cycle chain

View solution

Q. When the crank is at the outer dead centre, in a reciprocating steam engine, then the acceleration of the piston will be

View solution

Q. The example of successfully constrained motion is a

View solution

Q. Which one of the following can completely balance several masses revolving in different planes on a shaft?

View solution