Q. When a body is subjected to transverse vibrations, the stress induced in a body will be

View solution

Q. The magnitude of linear velocity of a point B on a link AB relative to point A is (where ω = Angular velocity of the link AB)

View solution

Q. A slender shaft supported on two bearings at its ends carries a disc with an eccentricity e from the axis of rotation. The critical speed of the shaft is Nc. If the disc is replaced by a second one of same mass but mounted with an eccentricily 2 e, then the critical speed of the shaft in the second case is

View solution

Q. The mechanism in which two are turning pairs and two are sliding pairs, is called a

View solution

Q. In a multiple V-belt drive, all the belts should stretch at the same rate.

View solution

Q. In a reciprocating engine, usually __________ of the reciprocating masses are balanced.

View solution

Q. The cam follower generally used in air-craft engines is

View solution

Q. In a locomotive, the maximum magnitude of the unbalanced force along the perpendicular to the line of stroke, is known as

View solution

Q. If ω/ωn is very low for a body vibrating under steady state vibrations, the phase angle for all values of damping factors, will tend to approach

View solution

Q. The factional torque for square thread at the mean radius r while raising load W is given by

View solution

Q. Whitworth quick return motion mechanism is an inversion of a double slider crank chain.

View solution

Q. The maximum gyroscopic couple acting on the ship tends to shear the holding down bolts.

View solution

Q. In a multiple V-belt drive, when a single belt is damaged, it is preferable to change the complete set to

View solution

Q. A force acting in the opposite direction to the motion of the body is called force of friction.

View solution

Q. A shaft has two heavy rotors mounted on it. The transverse natural frequencies, considering each of the rotor separately, are 100 Hz and 200 Hz respectively. The lowest critical speed is

View solution

Q. When two pulleys are connected by means of an open belt drive, then both the pulleys will rotate is opposite directions.

View solution

Q. A mechanism consisting of four links is called a __________ mechanism.

View solution

Q. The amplitude of vibration is always __________ the radius of the circle.

View solution

Q. An involute pinion and gear are in mesh. If both have the same size of addendum, then there will be an interference between the

View solution

Q. In vibration isolation system, if ω/ωn > 1, then the phase difference between the transmitted force and the disturbing force is

View solution