Q. The motion between a pair which takes place in __________ is known as incompletely constrained motion.

View solution

Q. The direction of linear velocity of any point on a link with respect to another point on the same link is

View solution

Q. The periodic time of a compound pendulum is __________ when the distance between the point of suspension and the centre of gravity is equal to the radius of gyration of the body about its centre of gravity.

View solution

Q. When the pitching of a ship is upward, the effect of gyroscopic couple acting on it will be

View solution

Q. The unbalanced force due to reciprocating masses

View solution

Q. The frictional torque transmitted in a flat pivot bearing, considering uniform pressure, is (where μ = Coefficient of friction, W = Load over the bearing, and R = Radius of bearing surface)

View solution

Q. In Meyer's expansion valve, the main valve is driven by an eccentric having an angle of advance from

View solution

Q. A kinematic chain is known as a mechanism when

View solution

Q. When the pitching of a ship is __________ the effect of gyroscopic couple acting on it will be to move the ship towards port side.

View solution

Q. There are six gears A, B, C, D, E and F in a compound train. The numbers of teeth in the gears are 20, 60, 30, 80, 25 and 75 respectively. The ratio of angular speeds of the driven (F) to the driver (A) of the drive is

View solution

Q. The velocity of a body moving with simple harmonic motion is __________ at the mean position.

View solution

Q. A rotor which is balanced statically but not dynamically is supported on two bearings L apart and at high speed of the rotor, reaction on the left bearing is R. The right side of the bearing is shifted to a new position 2 L apart from the left bearing. At the same rotor speed, dynamic reaction on the left bearing in the new arrangement will

View solution

Q. If the pressure angle is __________ , a reciprocating follower will jam in its bearings.

View solution

Q. The D-slide valve is also known as

View solution

Q. When the load on the engine increases, it becomes necessary to increase the supply of working fluid and when the load decreases, less working fluid is required. The supply of the working fluid to the engine is controlled by a

View solution

Q. V-belts are usually used for

View solution

Q. Sensitiveness of the governor is defined as the ratio of the

View solution

Q. The two parallel and coplaner shafts are connected by gears having teeth parallel to the axis of the shaft. This arrangement is known as

View solution

Q. The relative velocity of B with respect to A in a rigid link AB is

View solution

Q. In a pantograph, all the pairs are

View solution