Q. The purpose of a riser is to

View solution

Q. The blank diameter used in thread rolling will be

View solution

Q. The cross-section of a chisel is usually

View solution

Q. A plug gauge is used to check the diameter of shafts and studs.

View solution

Q. In back-hand welding, the angle between the welding torch and the work is kept as

View solution

Q. In welding copper alloys with TIG arc welding

View solution

Q. The algebraic difference between the minimum limit and the basic size is called

View solution

Q. The temperature of oxy-hydrogen flame is __________ oxy-acetylene flame.

View solution

Q. Which of the following methods can be used for manufacturing 2 metre long seamless metallic tubes?

View solution

Q. A saw which cuts wood during the return stroke of the saw is known as

View solution

Q. In arc welding, the electric arc is produced between the work and the electrode by

View solution

Q. In a centrifugal casting method

View solution

Q. The draft or taper allowance on casting is generally

View solution

Q. Which of the following welding process uses non-consumable electrodes?

View solution

Q. In a bilateral system of tolerance, the tolerance is allowed on

View solution

Q. The machining allowance provided on patterns depends upon

View solution

Q. In submerged arc welding, an arc is produced between a

View solution

Q. In shielded arc welding

View solution

Q. In a die casting method, the molten metal is forced into mould under high pressure.

View solution

Q. In a centrifugal casting method, the impurities are collected in the centre of the casting.

View solution