Q. Tandem drawing of wires and tubes is necessary because

View solution

Q. In a __________ , both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram.

View solution

Q. For welding plates of thickness more than 12.5 mm, its edges

View solution

Q. In electric resistance welding, voltage required for heating is

View solution

Q. Most of the oxy-acetylene welding is done with

View solution

Q. The cutting edge of a chisel should be

View solution

Q. Scab is a casting defect which occurs as sand patches on the upper surface of a casting.

View solution

Q. Cold working requires much higher pressure that hot working.

View solution

Q. The operation of bending a sheet of metal along a curved axis, is known as

View solution

Q. In a __________ , two or more operations are performed simultaneously at the single stroke of the ram.

View solution

Q. A rip saw

View solution

Q. The welding set up is said to have reversed polarity when the work is connected to the negative terminal and the electrode holder to the positive terminal.

View solution

Q. A jolt machine is used to

View solution

Q. If the sand is too fine, its permeability will be high.

View solution

Q. Which of the following statement is wrong?

View solution

Q. In a compound die

View solution

Q. A file removes the metal during

View solution

Q. A pouring basin acts as a reservoir for the molten metal.

View solution

Q. In bending operation, the metal takes the shape of a punch.

View solution

Q. The cold working of metals is carried out

View solution