Q. Sand wash is a casting defect which

View solution

Q. Cold working distorts grain structure and does not provide an appreciable reduction in size.

View solution

Q. Cast iron and steel pipes are produced by

View solution

Q. The acetylene cylinder is usually painted with

View solution

Q. In order to ram the sand harder at the back of the mould and softer on the pattern face, a __________ is used.

View solution

Q. The property of sand due to which the sand grains stick together, is called

View solution

Q. The temperature produced by oxy-hydrogen flame is about

View solution

Q. The process of decreasing the cross-section of a bar and increasing its length, is called

View solution

Q. A casting defect which occurs due to improper venting of sand is known as

View solution

Q. Swab is used for

View solution

Q. The temperature of the inner luminous cone of neutral flame is about

View solution

Q. The metal patterns as compared to wooden patterns require less

View solution

Q. In blanking operation, the clearance is provided on

View solution

Q. In piercing operation, the clearance is provided on

View solution

Q. If an aluminium pattern made from a wooden master pattern is to be used for grey iron castings, then the shrinkage allowance allowed on the wooden pattern should be

View solution

Q. For arc welding

View solution

Q. When the file is moved to and fro over the work, it is known as

View solution

Q. The hot working of metals is carried out

View solution

Q. In a four high rolling mill, the diameter of backing up rolls is __________ the diameter of working rolls.

View solution

Q. The welding process used to join the ends of two pipes of uniform cross-section, is

View solution