Q. In the below figure, __________ represents glass.

View solution

Q. A circular shaft fixed at, A has diameter D for half of its length and diameter D/2 over the other half, as shown in the below figure. If the rotation of B relative to A is 0.1 radian, the rotation of C relative to B will be

View solution

Q. For the beam shown in the below figure, the shear force diagram between A and B is

View solution

Q. In the below figure, the point C represents

View solution

Q. The radius of the Mohr 's circle in the given figure is equal to

View solution

Q. In the below figure, the point E represents the maximum stress.

View solution

Q. The given figure shows the Mohr's circle of stress for two unequal and like principal stresses (σx and σy) acting at a body across two mutually perpendicular planes. The normal stress on an oblique section making an angle θ with the minor principle plane is given by

View solution

Q. For the beam shown in the below figure, the shear force at A is equal to

View solution

Q. A ship with jet propulsion draws water through inlet orifices at right angles to the direction of its motion. The propelling force of the jet is (where a = Area of the jet, Vr = Relative velocity of the jet and ship = V + v, v = Velocity of the ship, and V = Velocity of the jet issuing from the ship)

View solution

Q. In a stress-strain diagram as shown in the below figure, the curve A represents

View solution

Q. For a beam, as shown in the below figure, the deflection at C is (where E = Young's modulus for the beam material, and I = Moment of inertia of the beam section. )

View solution

Q. A rectangular beam subjected to a bending moment is shown in the below figure. The upper layer of the beam will be in tension.

View solution

Q. When a body is subjected to a direct tensile stress (σx) in one plane accompanied by a simple shear stress (τxy), the maximum shear stress is

View solution

Q. The maximum bending moment for the beam shown in the below figure, is

View solution

Q. When a body is subjected to a direct tensile stress (σx) in one plane accompanied by a simple shear stress (τxy ), the maximum normal stress is

View solution

Q. The relation between modulus of elasticity (E) and modulus of rigidity (C) is given by

View solution

Q. When the retained material is subjected to some superimposed or surcharged load, the total horizontal pressure due to surcharged load is (where p = Intensity of the supercharged load)

View solution

Q. In a stress-strain diagram for mild steel, as shown in the below figure, the point A represents

View solution

Q. In a leaf spring, the deflection at the centre is

View solution

Q. When a body is subjected to direct tensile stresses (σx and σy ) in two mutually perpendicular directions, accompanied by a simple shear stress τxy , then in Mohr's circle method, the circle radius is taken as

View solution