Question

What is the ratio of depth of liquid in vessel to the diameter of tank (H:Dt)?

a.

1 : 1

b.

2 : 1

c.

4 : 1

d.

none of these

Answer: (a).1 : 1

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. What is the ratio of depth of liquid in vessel to the diameter of tank (H:Dt)?

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Radial flow impellers

Q. Transient flow range of mixing speed is obtained for

Q. A typical ceiling fan would be best described as a(n)

Q. What is the ratio of diameter of impeller to the diameter of tank (Da:Dt)?

Q. The rate limiting step in the movement of oxygen from the gas phase in a bubble to the cell is the movement of oxygen molecules through

Q. Penetration theory assumes that turbulent eddies travel from the bulk of the phase to the interface where they remain constant for a constant exposure time (te). The model correlating KL, mass transfer coefficient and DAB, diffusivity can be expressed as

Q. The oxygen uptake requirements of a microbial population is characterized by the following parameters: μm = 0.2 h­¹, K0 = 0.2 mg O₂.l­¹, Y0 = 0.5 mg dry weight/mg O₂ and C0,crit=0.8 mg.l­¹ The required concentration of cells is 1000 mg.l­¹ and the saturation oxygen concentration of the medium is 5.8 mg.l­¹. The required KLa must be greater than

Q. Which have the maximum resistance while transferring carbon dioxide from the bulk liquid to an air bubble?

Q. If liquid density and viscosity remains constant, then the Reynolds number in a stirred tank reactor will vary with the

Q. Power number is ratio of

Q. The volume of liquid (VL) in a cylindrical reactor can be calculated from the liquid height (HL) and tank diameter (Dt) using the following equation

Q. The average fractional gas hold up (H) can be given as (where Zf and Zl are the level of aerated and clear liquid respectively)

Q. Which of the following(s) is/are non-mechanically agitated reactors?

Q. Which of the following best explains the reasons for using axial flow impellers in crystallization and precipitation reactions?

Q. When the height of an aerated bioreactor is increased, it will increase the oxygen transfer rate by

Q. Which of the following is correct for the off-centre impellers?

Q. The power required by an impeller in a gas sparged system compare to the power required by impeller operating at same speed in a gas free liquid is usually

Q. Which of the following stirrer requires least amount of energy for same yield?

Q. A reactor has a total volume of 50,000 litres. If it has a headspace volume of 10,000 litres, then volume of liquid in the reactor will be

Q. A cylindrical reactor fitted with Rushton Turbine has a liquid volume of 100,000 litres. It has an aspect ratio (the ratio of the channel height to the width) of 2:1. The diameter of the impeller should be approximately:

Recommended Subjects

Are you eager to expand your knowledge beyond Biochemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!