Q. A uniform slope was measured by the method of stepping. If the difference in level between two points is 1.8 m and the slope distance between them is 15 m, the error is approximately equal to

View solution

Q. Which one of the following procedures for getting accurate orientation is the most distinctive feature of the art of plane tabling

View solution

Q. A clinometer is used for

View solution

Q. Diurnal variation of magnetic declination is

View solution

Q. The 'fix' of a plane table from three known points, is good, if

View solution

Q. The construction of optical square is based, on the principle of optical

View solution

Q. If the smallest division of a vernier is longer than the smallest division of its primary scale, the vernier is known as

View solution

Q. Cross-staff is used for

View solution

Q. The 'point of curve' of a simple circular curve, is

View solution

Q. For orientation of a plane table with three points A, B and C, Bessel's drill is

View solution

Q. The minimum range for sliding the focusing lens in the internal focusing telescope for focusing at all distances beyond 4 m is

View solution

Q. If a tacheometer is fitted with an anal-latic lens

View solution

Q. Volume of the earth work may be calculated by

View solution

Q. Which one of the following mistakes/errors may be cumulative + or - :

View solution

Q. The orthographical projection of a traverse leg upon the reference meridian, is known as

View solution

Q. The whole circle bearing of a line is 290°. Its reduced bearing is

View solution

Q. Pick up the correct statement from the following :

View solution

Q. Ramsden eye-piece consists of

View solution

Q. The distance between steps for measuring down hill to obtain better accuracy

View solution

Q. The tangent to the liquid surface in a level tube, is parallel to the axis of the level tube at

View solution