Q. While measuring with a metallic tape of 30 m length pull should be applied

View solution

Q. With usual notations, the expression V²/gR represents

View solution

Q. An angle of deflection right, may be directly obtained by setting the instrument to read

View solution

Q. The method of finding out the difference in elevation between two points for eliminating the effect of curvature and refraction, is

View solution

Q. Transition curves are introduced at either end of a circular curve, to obtain

View solution

Q. The horizontal angle between true meridian and magnetic meridian, is known

View solution

Q. For preparation of a contour plan for a route survey

View solution

Q. Flint glass

View solution

Q. The zero of the graduated circle of a prismatic compass is located at

View solution

Q. The ratio of the linear displacement at the end of a line, subtended by an arc of one second to the length of the line, is

View solution

Q. The co-ordinate of a point measured perpendicular to the parallel, is called

View solution

Q. The magnetic meridian at any point, is the direction indicated by a freely suspended

View solution

Q. If the radius of a simple curve is 600 m, the maximum length of the chord for calculating offsets, is taken

View solution

Q. Accuracy of elevation of various points obtained from contour map is limited to

View solution

Q. Magnetic bearing of a survey line at any place

View solution

Q. Perpendicularity of an offset may be judged by eye, if the length of the offset is

View solution

Q. The bearings of two traverse legs AB and BC are N52° 45' E and N34° 30' E respectively. The deflection angle is

View solution

Q. A lemniscate curve will not be transitional throughout, if its deflection angle, is

View solution

Q. A standard steel tape of length 30 m and cross-section 15 x 1.0 mm was standardised at 25°C and at 30 kg pull. While measuring a base line at the same temperature, the pull applied was 40 kg. If the modulus of elasticity of steel tape is 2.2 x 10⁶ kg/cm², the correction to be applied is

View solution

Q. The bearing of AB is 190° and that of CB is 260° 30'. The included angle ABC, is

View solution