Question
a.
a steep surface
b.
a flat surface
c.
an inclined plane surface
d.
curved surface.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Straight, parallel and widely spaced contours represent
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The theodolites used for making tacheometric observations by optical wedge system, are
View solution
Q. Tilt of the staff in stadia tacheometry increases the intercept if it is
View solution
Q. To orient a plane table at a point with two inaccessible points, the method generally adopted, is
View solution
Q. The combined effect of curvature and refraction over a distance L kilometres is
View solution
Q. Number of links per metre length of a chain are
View solution
Q. Staff readings on pegs x and y from X station are 1.755 m and 2.850 m, and from station Y on staff head at Y and X are 0.655 m and 1.560 m. If reduced level of X is 105.5 m, the reduced level of Y is
View solution
Q. The constant vertical distance between two adjacent contours, is called
View solution
Q. The reduced level of a floor is 99.995 m, the staff reading on the floor is 1.505 m. If the inverted staff reading against the roof is 1.795 m, the floor level below the slab, is
View solution
Q. The correction to be applied to each 30 metre chain length along θ° slope, is
View solution
Q. If + 0.8% grade meets - 0.7% grade and the rate of change of grade for 30 m distance is 0.05, the length of the vertical curve will be
View solution
Q. The included angles of a theodolite traverse, are generally measured
View solution
Q. Location of contour gradient for a high way is best set out from
View solution
Q. If h1 and h2 are the differences in level between ground and the formation levels, m is the slope of the sloping sides. D is the distance between the cross sections then, prismoidal correction for a level section is
View solution
Q. In a telescope the object glass of focal length 14 cm, is located at 20 cm from the diaphragm. The focussing lens is midway between them when a staff 16.50 m away is focussed. The focal length of the focussing lens, is
View solution
Q. The staff reading at a distance of 80 m from a level with the bubble at its centre is 1.31 m. When the bubble is moved by 5 divisions out of the centre, the reading is 1.39 m. The angular value of the one division of the bubble, is
View solution
Q. If i is the stadia distance, f is the focal length and d is the distance between the objective and vertical axis of the techeometer, the multiplying constant, is
View solution
Q. The back staff reading on a B.M. of R.L. 500.000 m is 2.685 m. If foresight reading on a point is 1.345 m, the reduced level of the point, is
View solution
Q. It is more difficult to obtain good results while measuringhorizontal distance by stepping
View solution
Q. The additional lines which are measured to show the correctness of the chain surveying are called:
View solution
Q. The line normal to the plumb line is known as
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!