Q. If H is height of the liquid above the sill, the effect of end contractions, according to Francis formula, is

View solution

Q. Pick up the correct statement from the following :

View solution

Q. The pressure less than atmospheric , pressure, is known

View solution

Q. A rise or fall of liquid in a glass tube of a very small diameter when dipped is

View solution

Q. To measure very low pressure, we use

View solution

Q. If v1 and v2 are the velocities of flow before and after sudden enlargement in a pipe, the head loss given by Carnot and Borda equation, is

View solution

Q. Equation of continuity of fluids is applicable only if

View solution

Q. The flow in open channel is said to be critical if the Froude number is :

View solution

Q. An orifice is an opening in a vessel with

View solution

Q. The imaginary line drawn such that the tangents at its all points indicate the direction of the velocity of the fluid particles at each point, is called

View solution

Q. To avoid the tendency of separation of liquid flow, the most suitable ratio of the diameters of the throat and the pipe, is

View solution

Q. The instrument used for measuring the velocity of flow, is known as

View solution

Q. For a long pipe, the head loss

View solution

Q. On a flow net diagram, the distance between two consecutive steam lines at two successive sections are 1 cm and 0.5 cm respectively. If the velocity at the first section is 1 m/sec, the velocity at the second is

View solution

Q. The flow is called rotational if its velocity normal to the plane of area is equal to

View solution

Q. In flowing liquids pitot tubes are used measure

View solution

Q. Capillary rise of water is

View solution

Q. A water tank partially filled with water is being carried on a truck moving with a constant horizontal acceleration. The level of the water

View solution

Q. An error of 1% in measuring the head of water over the crest of a rectangular weir, produces an error in the discharge which is equal to

View solution

Q. Flow of water in pipes of diameter more than 3 metres, can be measured by

View solution