Q. For design purposes, the normal rate of infiltration of ground water into the sewer, is

View solution

Q. The effluent of a septic tank is

View solution

Q. The drainage area of a town is 12 hectares. Its 40% area is hard pavement (K = 0.85), the 40% area is unpaved streets (K = 0.20) and the remaining is wooded areas (K = 0.15). Assuming the time of concentration for the areas as 30 minutes and using the formula Ps = 900/t+60 the maximum run off is

View solution

Q. The detention period for plain sedimentation water tanks, is usually

View solution

Q. To prevent settling down of sewage both at the bottom and on the sides of a large sewer, self-cleaning velocity recommended for Indian conditions, is

View solution

Q. Pick up the correct statement from the following :

View solution

Q. In sewers the gas generally found, is

View solution

Q. A sewer running partially full and hurried with back filled, fails in compression due to

View solution

Q. A manhole is classified as shallow if its depth is between

View solution

Q. The ratio of the diameter of a circular section and the side of a square section hydraulically equivalent, is

View solution

Q. Pick up the correct statement from the following :

View solution

Q. For trunk and out-fall, the type of sewers generally used, is

View solution

Q. Pick up the incorrect statement from the following :

View solution

Q. Hydraulic mean radius is

View solution

Q. Sewer ventilating columns are generally placed at

View solution

Q. In case of Imhoff tanks,

View solution

Q. If the depth of partial flow in a sewer of diameter 2 m, is 50 cm, its wetted perimeter is

View solution

Q. A drop manhole is provided if

View solution

Q. In a city the ratio of the drainage to sewage is 20, the percentage discharge passing through non-monsoon periods, is

View solution

Q. In septic tanks,

View solution