Q. The thickness of the flange of a Tee beam of a ribbed slab is assumed as

View solution

Q. In a singly reinforced beam, if the permissible stress in concrete reaches earlier than that in steel, the beam section is called

View solution

Q. The length of the lap in a compression member is kept greater than bar diameter x (Permissible stress in bar / Five times the bond stress) or

View solution

Q. In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed

View solution

Q. If the shear stress in a R.C.C. beam is

View solution

Q. On piles, the drop must be at least

View solution

Q. If the size of a column is reduced above the floor, the main bars of the columns, are

View solution

Q. The system in which high tensile alloy steel bars (silica manganese steel) are used as prestressing tendons, is known as

View solution

Q. The minimum clear cover for R.C.C. columns shall be

View solution

Q. If the loading on a prestressed rectangular beam, is uniformly distributed, the tendon to be provided should be .

View solution

Q. An under-reinforced section means

View solution

Q. The spacing of transverse reinforcement of column is decided by the following consideration.

View solution

Q. The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than

View solution

Q. Piles are usually driven by

View solution

Q. In favourable circumstances a 15 cm concrete cube after 28 days, attains a maximum crushing strength

View solution

Q. The angle of internal friction of soil mass is the angle whose

View solution

Q. The anchorage value of a hook is assumed sixteen times the diameter of the bar if the angle of the bend, is

View solution

Q. Top bars are extended to the projecting parts of the combined footing of two columns L distance apart for a distance of

View solution

Q. A pre-stressed concrete member

View solution

Q. A part of the slab may be considered as the flange of the T-beam if

View solution