Q. Pick up the assumption for the design of a prestressed concrete member from the following :

View solution

Q. If the diameter of the main reinforcement in a slab is 16 mm, the concrete cover to main bars is

View solution

Q. Side face reinforcement shall be provided in the beam when depth of the web in a beam exceeds

View solution

Q. The Young's modulus of elasticity of steel, is

View solution

Q. The maximum permissible size of aggregates to be used in casting the ribs of a slab, is

View solution

Q. In a simply supported slab, alternate bars are curtailed at

View solution

Q. The diameter of main bars in R.C.C. columns, shall not be less than

View solution

Q. The breadth of a ribbed slab containing two bars must be between

View solution

Q. A ribbed slab is provided for

View solution

Q. For a number of columns constructed in a rcjw, the type of foundation provided, is

View solution

Q. As the percentage of steel increases

View solution

Q. If W is weight of a retaining wall and P is the horizontal earth pressure, the factor of safety against sliding, is

View solution

Q. The minimum thickness of the cover at the end of a reinforcing bar should not be less than twice the diameter of the bar subject to a minimum of

View solution

Q. For the design of a simply supported T-beam the ratio of the effective span to the overall depth of the beam is limited to

View solution

Q. In the zone of R.C.C. beam where shear stress is less than 5 kg/cm², nominal reinforcement is provided at a pitch of

View solution

Q. The section of a reinforced beam where most distant concrete fibre in compression and tension in steel attains permissible stressess simultaneously, is called

View solution

Q. The width of the flange of a L-beam, should be less than

View solution

Q. A singly reinforced concrete beam of 25 cm width and 70 cm effective depth is provided with 18.75 cm² steel. If the modular ratio (m) is 15, the depth of the neutral axis, is

View solution