Q. For holding a rail in position, no chairs are used for

View solution

Q. Distance between the inner rail and check rail provided on sharp curve, is

View solution

Q. Coal ash (or cinder) is used in initial stages of a new construction of railway for

View solution

Q. The tread of wheels is provided an outward slope of

View solution

Q. On a straight railway track, absolute levels at point A on two rails are 100.550 m and 100.530 m and the absolute levels at point B 100 m apart are 100.585 m and 100.515 m respectively, the value of twist of rails per metre run, is

View solution

Q. Bearing plates are used to fix

View solution

Q. A welded rail joint is generally

View solution

Q. Safe speed (V) on a curve of radius 970 metres provided with two transition curves on Board Gauge track, is

View solution

Q. Mr. W. Simms, the consulting Engineer to the Government of India recommended the gauge for Indian railways

View solution

Q. If absolute levels of rails at the consecutive axles A, B, and C separated by 1.8 metres are 100.505 m, 100.530 m, and 100.525 m respectively, the unevenness of rails, is

View solution

Q. A CST-9 sleeper consists of

View solution

Q. Charles Vignoles invented the flat footed rails in

View solution

Q. To design a cross-over between parallel tracks, the required components are :

View solution

Q. Best wood for wooden sleepers is

View solution

Q. The rail section which is not used on Indian metre gauge tracks, is

View solution

Q. Dimensions of a plate girder, are :

View solution

Q. Rail joint supported on a single sleeper, is known

View solution

Q. Maximum wheel base distance provided on Indian B.G. tracks, is

View solution

Q. For flat bottom sleepers, maximum size of ballast, is

View solution

Q. Coning of wheels

View solution