Question

Rails are fixed on steel sleepers

a.

by bearing plates

b.

by dog spikes

c.

by keys in lugs or jaws

d.

none of these.

Posted under Civil Engineering

Answer: (c).by keys in lugs or jaws

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Rails are fixed on steel sleepers

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. If a is average number of peaks more than 10 mm of uneveness per kilometre, b is average number peaks more than 6 mm for gauge variation per kilometre and c is average number of peaks more than 2 mm twist per metre, then composite current recording index (Ic), as recommended by Indian Northern Railways, is

Q. Pick up the correct statement from the following:

Q. The standard width of ballast for M.G. track in Indian Railways, is kept

Q. To prevent creep in rails, the steel sleepers are fixed with rails by clips, bolts and

Q. The standard dimensions of a wooden sleeper for a B.G. railway track are

Q. In Indian railways, the ratio of axle load and weight of rail, is

Q. On Broad Gauge main lines with maximum traffic loads, the rail section preferred to, is

Q. If D is the distance between the parallel sidings and α is the angle of crossing, the distance between the noses of crossing measured parallel to the main track, is

Q. On B.G. tracks the distance of outer signal from station limit is kept

Q. The rails get out of their original positions due to insufficient expansion gap. This phenomenon is known

Q. Wing rails are provided

Q. Burnettising is done for the preservation of

Q. 30 m long rails are used in

Q. Minimum gradient in station yards is generally limited to

Q. If n is length of a rail in metres, the number of sleepers per rail length generally varies from

Q. For inspection and packing of ballast, each pot sleeper is provided with

Q. Each block of a two-block concrete sleeper is

Q. The effective bearing area of all types of sleepers, is

Q. For points and crossings, maximum size of ballast, is

Q. The main function of sleepers, is

Recommended Subjects

Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!