Q. A compound truss may be formed by connecting two simple rigid frames, by

View solution

Q. In a shaft, the shear stress is not directly proportional to

View solution

Q. The load on a spring per unit deflection, is called

View solution

Q. The maximum height of a masonry dam of a triangular section whose base width is b and specific gravity s, is

View solution

Q. At any point of a beam, the section modulus may be obtained by dividing the moment of inertia of the section by

View solution

Q. The equivalent length of a column of length L, having one end fixed and other end hinged, is

View solution

Q. The radius of gyration of a rectangular section (depth D, width B) from a centroidal axis parallel to the width is

View solution

Q. The ratio of the length and depth of a simply supported rectangular beam which experiences maximum bending stress equal to tensile stress, due to same load at its mid span, is

View solution

Q. The equivalent length of a column of length L having one end fixed and the other end free, is

View solution

Q. The locus of the moment of inertia about inclined axes to the principal axis, is

View solution

Q. The ratio of maximum and average shear stresses on a rectangular section, is

View solution

Q. For a strongest rectangular beam cut from a circular log, the ratio of the width and depth, is

View solution

Q. The ratio of the section modulus of a square section of side B and that of a circular section of diameter D, is

View solution

Q. In case of principal axes of a section

View solution

Q. The ratio of the stresses produced by a suddenly applied load and by a gradually applied load on a bar, is

View solution

Q. Slenderness ratio of a long column, is

View solution

Q. Gradually applied static loads do not change with time their

View solution

Q. A short column (30 cm x 20 cm) carries a load P1 at 4 cm on one side and another load P2 at 8 cm on the other side along a principal section parallel to longer dimension. If the extreme intensity on either side is same, the ratio of P1 to P2 will be

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Maximum principal stress theory for the failure of a material at elastic point, is known

View solution