Q. In places where the soil is soft and has small resistance to the flow of concrete, which one of the following types of piles, is used

View solution

Q. In grillage foundations a minimum 15 cm cover is provided on

View solution

Q. The skirting/dado in a bath roof should be upto

View solution

Q. The maximum bearing capacity of soil is that of

View solution

Q. Raft foundations are used for :

View solution

Q. For brick construction, the lime-sand mortar, is

View solution

Q. An arch constructed with finely dressed stones, is known

View solution

Q. Cavity wall is generally provided for

View solution

Q. Dampness causes

View solution

Q. The angle between skew back of a flat arch and the horizontal, is kept approximately equal to

View solution

Q. In clay soil

View solution

Q. Pick up the incorrect statement from the following :

View solution

Q. Depth of lean concrete bed placedat the bottom of a wall footing, is kept

View solution

Q. For a wall carrying heavy load on low bearing capacity soil,

View solution

Q. The foundation which consists of a thick reinforced cement slab covering whole area to support heavy concentrated structural loads, is known as

View solution

Q. Bearing capacity of soils cannot be improved by

View solution

Q. To support a heavy structure in sandy soil, the type of foundation generally used, is

View solution

Q. A floor constructed with 3 mm marble chips, is known

View solution

Q. The position of a brick when laid on its side 9 cm x 9 cm with its frog in the vertical plane, is called

View solution

Q. You are asked to design and supervise a truss for a factory to have spans 6 m to 9 m. The type of the truss you will use, is

View solution