Question
a.
shear strength
b.
tensile strength
c.
compressive strength
d.
none of these.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Allowable shear strength of concrete, depends upon
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The most useless aggregate is one whose surface texture is
View solution
Q. To obtain a very high strength concrete, use very fine grained
View solution
Q. For the construction of R.C.C. slabs, columns, beams, walls, etc. the grade of concrete mix used, is
View solution
Q. The type of aggregates of same nominal size, which contain less voids when compacted, are
View solution
Q. For the construction of cement con-certe dams, the maximum permissible size of the aggregates, is
View solution
Q. Permissible compressive strength of M 200 concrete grade is
View solution
Q. For preparing a test-specimen, it is necessary
View solution
Q. Concrete containing
View solution
Q. An ordinary Portland cement when tested for its fineness, should not leave any residue on I.S. seive No. 9, more than
View solution
Q. The top diameter, bottom diameter and the height of a slump mould are :
View solution
Q. Workability of concrete mix with low water cement ratio is determined by
View solution
Q. While designing an air entrained concrete
View solution
Q. Ordinary Portland cement is manufactured from
View solution
Q. A flaky aggregate is said to be elongated if its length is
View solution
Q. To prevent segregation, the maximum height for placing concrete, is
View solution
Q. If the various concrete ingredients i.e. cement, sand and aggregates are in the ratio of 1:3:6, the grade of concrete, is
View solution
Q. Water cement ratio is generally expressed in volume of water required per
View solution
Q. Pick up the incorrect statement from the following:
View solution
Q. In slump test, each layer of concrete is compacted by a steel rod 60 cm long and of 16 mm diameter for
View solution
Q. If the average compressive strength is 4000 kg/cm² and standard deviation is 500, the co-efficient of variation is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!