Q. The ratio of the effective length of a column and minimum radius of gyration of its cross-sectional area, is known

View solution

Q. Failure of riverted joints is due to

View solution

Q. The maximum load to which a fillet joint of length L can be subjected to, is

View solution

Q. Beams of uniform strength are preferred to those of uniform section because these are economical for

View solution

Q. The moment diagram for a cantilever whose free end is subjected to a bending moment, will be a

View solution

Q. Reactions at the supports of a structure can be determined by equating the algebraic sum of

View solution

Q. The bending moment is maximum on a section where shearing force

View solution

Q. Pick up the correct statement from the following :

View solution

Q. A short masonry pillar is 60 cm x 60 cm in cross-section, the core of the pillar is a square whose side is

View solution

Q. A rectangular log of wood is floating in water with a load of 100 N at its centre. The maximum shear force in the wooden log is

View solution

Q. The following assumption is not true in the theory of pure torsion :

View solution

Q. Pick up the correct assumption of the theory of simple bending

View solution

Q. The neutral axis of a beam cross-section must

View solution

Q. If the beam is supported so that there are only three unknown reactive elements at the supports. These can be determined by using the following fundamental equation of statics

View solution

Q. In a solid arch, shear force acts

View solution

Q. A three hinged arch is loaded with an isolated load 1000 kg at a horizontal distance of 2.5 m from the crown, 1 m above the level of hinges at the supports 10 metres apart. The horizontal thrust is

View solution

Q. The section modulus of a rectangular section is proportional to

View solution

Q. The property of a material by which it can be drawn to a smaller section, due to tension, is called

View solution

Q. The distance between the centres of adjacent rivets in the same row, is called

View solution

Q. Columns of given length, cross-section and material have different values of buckling loads for different end conditions. The strongest column is one whose

View solution