Q. For efficient working of a control meter, its throat length is approximately kept

View solution

Q. A control meter is preferred to a weir because

View solution

Q. A river is said to be of uniform section if in its section

View solution

Q. The run off is affected by

View solution

Q. The form factor of a drainage basin is obtained by dividing

View solution

Q. Isopiastic lines are the contours

View solution

Q. The coefficients of permeability of soils of an unconfined aquifer and another confined aquifer were determined by pumping water from the wells and observing the effect of water table in two test wells at equal distances was found to be equal. The total height of confined aquifer H is given by

View solution

Q. The radius of influence is

View solution

Q. When a constant discharge 2.91 litres/sec. was obtained in a pumping test, the draw downs in the test wells at 3 m and 6.184 m were 2.6 m and 0.3 m respectively. If over-all depth of the pumping well was 16 m, the permeability of the soil, is

View solution

Q. If h is the loss due to friction in a pipe. Total losses in strainer and bends may be taken as

View solution

Q. If the loss due to friction in pipes is 4 m, the total losses in strainer and bends may be taken as

View solution

Q. The rate of evaporation from reservoirs may be determined by

View solution

Q. In estimating the rate of evaporation from the reservoir surface, a pan 1.5 metres in diameter, was filled upto 8.0 cm. During a specified period of time, the rainfall recorded was 5 cm. 3 cm of water was removed from the pan to keep the depth of water. At the end of the time, the depth was 9 cm. If the pan coefficient is 0.6, the evaporation loss is

View solution

Q. Dicken's formula for high flood estimate, is useful only for the catchments in

View solution

Q. Relative humidity is the ratio of actual vapour pressure to the saturation vapour pressure

View solution

Q. Pick up correct statement from the following :

View solution

Q. Precipitation caused due to upward movement of warmer air as compared to surrounding air, is called

View solution

Q. Precipitation caused due to striking of air masses with a topographical feature, is called

View solution

Q. The specifications of most commonly used standard gauges in India, are

View solution

Q. Pick up the correct statement from the following :

View solution